If use_carrier is 0, then the MII monitor will first query thedevice's (via ioctl) MII registers and check the link state. If thatrequest fails (not just that it returns carrier down), then the MIImonitor will make an ethtool ETHOOL_GLINK request to attempt to obtainthe same information. If both methods fail (i.e., the driver eitherdoes not support or had some error in processing both the MII registerand ethtool requests), then the MII monitor will assume the link isup.
Third, the NVMe interface can transfer much larger amounts of data per I/O, and in some cases may be able to support more outstanding I/O requests, compared to the Xen PV block interface. This can cause higher I/O latency if very large I/Os or a large number of I/O requests are issued to volumes designed to support throughput workloads like EBS Throughput Optimized HDD (st1) and Cold HDD (sc1) volumes. This I/O latency is normal for throughput optimized volumes in these scenarios, but may cause I/O timeouts in NVMe drivers. The I/O timeout can be adjusted in the Linux driver by specifying a larger value for the nvme_core.io_timeout kernel module parameter.
Association Request To The Driver Failed Gentoo
Linux has a reputation of supporting old hardware very well by maintaining standardized drivers for a long time.[103] There are several industry associations and hardware conferences devoted to maintaining and improving support for diverse hardware under Linux, such as FreedomHEC. Over time, support for different hardware has improved in Linux, resulting in any off-the-shelf purchase having a "good chance" of being compatible.[104]
* Multiple patches to reduce the number of disconnections for WPA Enterprise roaming and Opportunistic Key Caching. (LP: #1187524) * In debian/patches: 0001-sme-fix-retry-after-auth-assoc-timeout-failure.patch, 0002-sme-optimize-recovery-from-common-load-balancing-mechanisms.patch, 0003-sme-blacklist-bss-on-first-failure-if-only-a-*.patch, 0004-sme-extend-load-balancing-optimization-in-bss-blacklisting.patch, 0005-sme-optimize-recovery-from-association-command-failures.patch, 0006-sme-add-timers-for-authentication-and-association.patch, 0007-sme-nl80211-set-cipher-suites.patch: Cherry-pick patches fixing SME (Session Management Entity) for the nl80211 driver, which works as a basis for the OKC patches. * In debian/patches: 0001-pmkokc-Set-portValid-TRUE-on-association-for-driver-based-4.patch, 0002-pmkokc-Clear-WPA-and-EAPOL-state-machine-config-pointer-on-.patch, 0003-pmkokc-Clear-driver-PMKSA-cache-entry-on-PMKSA-cache-expira.patch, 0004-pmkokc-Flush-PMKSA-cache-entries-and-invalidate-EAP-state-o.patch, 0005-pmkokc-Fix-proactive_key_caching-configuration-to-WPA-code.patch, 0006-pmkokc-RSN-Add-a-debug-message-when-considing-addition-of-O.patch, 0007-pmkokc-Clear-OKC-based-PMKSA-caching-entries-if-PMK-is-chan.patch, 0008-pmkokc-Move-wpa_sm_remove_pmkid-call-to-PMKSA-cache-entry-f.patch, 0009-pmkokc-Use-PMKSA-cache-entries-with-only-a-single-network-c.patch, 0010-pmkokc-PMKSA-Do-not-evict-active-cache-entry-when-adding-ne.patch, 0011-pmkokc-PMKSA-Set-cur_pmksa-pointer-during-initial-associati.patch, 0012-pmkokc-PMKSA-make-deauthentication-due-to-cache-entry-remov.patch, 0013-pmkokc-PMKSA-update-current-cache-entry-due-to-association-.patch: Cherry-pick patches to properly do OKC (Opportunistic Key Caching) which helps maintaining connectivity on networks secured with WPA Enterprise, especially on nl80211-based drivers -- these patches require SME, and add or fix key caching and handling of the cache entries. * debian/patches/force-enable-okc.patch: force Opportunistic Key Caching to be enabled. * debian/patches/less-aggressive-roaming.patch: use less aggressive roaming settings to avoid switching to another AP unnecessarily, when the actual signal level difference is small. * debian/patches/wpa_supplicant-dbus-null-error.patch: Don't send NULL to dbus_message_new_error(). * debian/patches/0001-nl80211-Fix-UNSPEC-signal-quality-reporting.patch: fix marking qual as invalid rather than signal level. * debian/patches/wpa_supplicant-squelch-driver-disconnect-spam.patch: recover cleanly from streams of disconnect messages (like on iwl3945). * debian/patches/wpa_sup...
pi@raspbmc:$ git clone http: //github.com/andreafabrizi/Dropbox-Uploader .gitCloning into 'Dropbox-Uploader'...error: Problem with the SSL CA cert (path? access rights?) while accessing http:// github.com/andreafabrizi/Dropbox-Uploader.git/info/refsfatal: HTTP request failed
In order to make that decision, PolicyKit needs three pieces ofinformation, the subject, object, and action. The subject is the user andprocess requesting the action, while the object is what entity the actionis being requested on. In a network configuration example, the subjectwould be a uid, along with additional identifying information such asSELinux security context, the action would be to change the association,and the object would be the network device. 2ff7e9595c
Comments